Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Rusty Gas Tank


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Lars on July 10, 2002 at 12:55:34 from (208.164.255.151):

In Reply to: Rusty Gas Tank posted by Wanna B on July 10, 2002 at 11:39:38:

Wanna:

One method of cleaning the fuel tank is to have a radiator shop boil it. They soak it like a radiator and then rinse with water several times.

The cost should be $75 to $100 assuming you prep the tank.

You will need to remove the fuel and wash the inside of the tank with a liquid dish detergent several times. You may want to drop a chain into the tank and shake to remove any sludge. Be careful to secure the chain so that it does fall in to the tank.

Treat the fuel with Heet (yellow bottle) or similar to remove residual water once installed.

The downside is that the process removes paint. In addition, if the corrosion is severe, it may eventually eat through the sheet metal regardless if the tank was cleaned or not. This in fact happened to me.

Another alternative is to purchase a replacement tank through a salvage yard. You may luck out find one in good condition. See if the seller will warrantee it for at least a year or see. You will need the tractor serial number and/or year to find the correct replacement.

There are other solutions. One of which is an acid etch/coating kit. The thought is to clean the tank and then apply a protective coating. Supposedly it will stop leaks. However, if the corrosion is not removed it will be trapped between the coating and sheet metal. Your local auto parts store or radiator shop may be possible source.

Good luck!



Follow Ups:




Post A Followup

:
:

: Re: Re: Rusty Gas Tank

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy