Farmall & IHC Tractors Discussion Board |
Re: fuel tank sealant question's?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Hogan on July 08, 2002 at 17:15:12 from (12.216.50.95):
In Reply to: fuel tank sealant question's? posted by Bob on July 08, 2002 at 11:57:56:
I used the POR-15 kit on a IH Scout tank. Just buy the kit and follow the directions. It is slicker than snot. Don't dick around with a chain or nails or anything else, that might knock a big hole in the tank making it useless. The kit comes with a Metal Ready solution that will clean and etch the metal in the tank. The sealant will put a nice coating over everything inside. The scout tank was 10 gallons and I used 1/3 of the sealer in the can. It sould do your 20 gallon tank just fine. Hint, I held a candle over the threads on the fuel sending unit screw holes. Filled the threads with wax to keep the sealer from sealing them shut. Not sure if these old tractors have a similar setup for the sender or not.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|