|
Farmall & IHC Tractors Discussion Board |
Hydraulic Pump Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by L.E. Davis on July 06, 2002 at 12:01:35 from (65.81.216.7):
I Recently installed a new pump on a 1953 super c tractor for my dad. when the tractor was used for the first time after istallation it blew the pump shaft seal and transferred all the hydraulic fluid to the crankcase.I pulled the pump and the seal was out of its seat in the pump housing and up against the drive gear on the pump. Since i was in the field many miles from a parts dept,i checked the seal ( it looked okay)and i drove it back into place and put everythingand after about twenty minutes of use it pumped the resvoir dry again.The seal was installed in the pump when it was purchased and i assumed it was okay.What am i missing here? is there supposed to be asnap ringto hold the seal in place or maybe a spacer between the pump gear and the seal? I do not have a service manual for this tractor. If anyone can help with this problem it would appreiated.Also could the system somehow be building too much pressure and causing this? thanks very much.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
