Farmall & IHC Tractors Discussion Board |
Re: Farmall Super M...ball park value and where to get parts?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene on July 03, 2002 at 13:04:34 from (65.57.16.206):
In Reply to: Farmall Super M...ball park value and where to get parts? posted by Rob on July 02, 2002 at 14:35:19:
Rob: I'll take a stab at some of your questions. The value varies a lot due to your location and condition. Most would be in the $1000 to $2200 range. Your best bet would be to spend a few hours looking at many of the posts here and down on the puller forum. Check the archives for M related posts too. Within a week you can get a lot better feel for what is involved and better able to make a good decision you can live with rather than my few comments. This website is quite good. The Farmall M is a good solid design. You could enjoy working and using it. Open the many items listed on the left side of this screen. Parts are listed near the top. Good luck. G.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|