Farmall & IHC Tractors Discussion Board |
Re: B Rear Axle Seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger on July 01, 2002 at 19:38:11 from (209.100.170.73):
In Reply to: B Rear Axle Seal posted by 1PWRFULH on July 01, 2002 at 14:33:21:
RC, I am currently restoring a Farmall B. It just so happens I was disassembling the final drive assy tonight. The final drive assy that the axle is in has it's own oil. It is filled through a plug on the front inside of the casting. To change the oil you have to remove the lower pan. The axle is removed by taking the inside cover off and removing the bolt on the end of the axle. Then remove the four bolts on the outside seal cap. Pull the axle out from the outside. I used one of those hammer pullers attached to the outside hub as the axle doesn't just slide out. There are several washers and parts on the axle that you need to keep in order for reassembly. The final drive bull gear is about 12 inches in diameter and will come out the bottom when the axle is pulled. Then for the hard part - you have to pull the bearing off the axle. It is pressed on the axle with a fairly good press fit. I pressed it out on my hydraulic press using one of those bearing pullers to get behind the bearing cap. If you don't have anything like that you can probably take to a local auto machine shop and have them press it off. You can use regular transmission 90 weight or equal in there after you get back together. I was able to get all gaskets and seals at the local Case IH dealer. Hope that helps. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|