Farmall & IHC Tractors Discussion Board |
Re: Farmall H Countershaft Nut ....Fun!!!! Bearings too expensive!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TNR on July 01, 2002 at 18:21:01 from (206.74.34.157):
In Reply to: Farmall H Countershaft Nut ....Fun!!!! Bearings too expensive! posted by Scott L. Swanson on July 01, 2002 at 10:40:20:
Im going to go with you.I have bought many bearing from IH and found them cheaper at say Bearings and drives and in some cases a better bearing than the one that I am replacing.I also have to add to that that the closest dealer to me is an hour away and B&D is only 20 minutes.Only problem I have run into going this route is if I come across a breaing that has literaly been griund away,I have to go IH to get it.To get the clip out I just use a screwdriver and kinda flip it out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|