Farmall & IHC Tractors Discussion Board |
Re: Farmall 200 engine rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mr. J on July 01, 2002 at 10:58:33 from (204.184.253.248):
In Reply to: Farmall 200 engine rebuild posted by Gary on June 30, 2002 at 21:18:47:
Gary, (I'm taking for granted you have the right sleeves) Sometimes when installing the sleeves, the O-Ring will hang on the side of the block and get pinched out when you install it. If you use STP or another lubricant, it will aid the O-Ring in staying in the groove. Sometimes, the O-Ring will even shear in half, this would cause a big leak. It sounds like you may have the wrong sleeve kit though as fast as the water comes through. Have you looked to see if the block case is cracked there as well? Just some things to check. Keep us informed, everyone loves to help, good luck and keep trying!! Jared Jeffries
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|