Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall A Brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith on June 30, 2002 at 02:39:27 from (66.84.172.149):
In Reply to: Re: Farmall A Brakes posted by big fred on June 29, 2002 at 20:49:07:
Just did the brakes in my 41 A and as was said the final drives are heavy. I paid $28 for the set of brakes at the local IH dealer. But you will also need two sets of seals because they will be shot when you remove the shafts. You will also have to match a male splined shaft to a female splined shaft and thats the tricky part of the whole thing. The pin that holds the bands to the final drive is two sided..... meaning the pin goes through the band support and into the final drive casting but also goes into the rear end casting. Hope that makes sense?? ---(---)--- > pin cast band cast And if you bend the pin you will not line up to the opposing part. ( trust me... I did it) Took my brother and I two hours to change them and had two sore backs after we were done. Good Luck Keith
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|