Farmall & IHC Tractors Discussion Board |
Re: Re: Lift Lever Pic For Mark and Jon
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scotty on June 26, 2002 at 09:39:22 from (199.231.49.128):
In Reply to: Re: Lift Lever Pic For Mark and Jon posted by Mark on June 26, 2002 at 07:15:32:
Mark, If I remember correctly that aluminum block is 4 1/4 thick which makes it line up with the front pad. Just use a straight edge off the front pad and measure the depth to the rear pad. I had to make a bushing for inside the gear sector bracket and a large washer on the outside. The lift lever goes in between the tank and the steering shaft. If I did it over again I would move the lever on the other side of the steering shaft so you wouldnt hit your hand on the shaft. scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|