Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: How easy to roll over on a narrow front M?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Don on June 18, 2002 at 05:02:35 from (141.129.1.114):
In Reply to: Re: Re: Re: How easy to roll over on a narrow front M? posted by The MATH Analysis on June 17, 2002 at 18:26:27:
I had some fork lift operator's training where I work and there is an easy analogy we were shown to determine a roll over situation.If you look at the rear axle of a forklift you will find they are set up quite similar to a WFE tractor.What determines the roll over point is the PIVOT POINT of the axle,which happens to be in the center.If lines are drawn from the pivot to the rear wheels,a triangle is formed.If the center of gravity of the machine shifts outside of that triangle,the machine WILL roll over.The best roll protection is avoiding sidehill operation,reduction of speed when turning corners,and,if loaders are being used,always keep the load as close to the ground as possible.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|