Farmall & IHC Tractors Discussion Board |
Re: H fuel line
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on June 17, 2002 at 10:56:56 from (63.110.182.225):
In Reply to: H fuel line posted by Dan G on June 17, 2002 at 10:19:57:
Get a steel automotive brake line, 5/16 x ?, cut off nuts and flares, this will get you a piece of tubing to match original part, then you need 2 nuts that as far as I know you can only get from Case-IH, part 222-503 or 19985R1, or 29899D, these are the correct nuts to seal into carb fitting and gas trap. You will have to determine length by a measurement. Allow enough to make a loop between ends IH did this to minimize expansion and vibration. Copper doesnt last, sems to get hard and breaks off, rubber quick fix but not a permanent cure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|