Farmall & IHC Tractors Discussion Board |
Re: setting Charge rate on 6V generator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 16, 2002 at 09:45:33 from (24.169.120.138):
In Reply to: setting Charge rate on 6V generator posted by KEN on June 16, 2002 at 09:14:11:
Ken - If your 300 has the original 3-brush generator, the 3rd brush is not adjustable to change charging rate. Rather the system charge rate is determined by the regulator. Suggest that if you haven't already installed a new regulator, do that next. It is possible to adjust the voltage regulator but it's fussy and the adjustments difficult to get right, even with proper tools and instruments. And if the regulator is more than a few years old it probably should be replaced anyway. One other thing to check: Make sure the regulator is SOLIDLY grounded. I like to run an auxiliary ground wire between a regulator base mounting screws and the grounded battery cable connection to the frame. I know it's not original but it often saves a lot of frustration later on, especially if you use the tractor infrequently and it sits outside.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|