Farmall & IHC Tractors Discussion Board |
Re: b farmall throttle lever notches worn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by boog on June 16, 2002 at 09:01:09 from (66.73.129.140):
In Reply to: b farmall throttle lever notches worn posted by mark sullivan on June 14, 2002 at 22:20:21:
There is an aftermarket throttle avaiable that uses a friction plate instead of notches. Another advantage is that you can get the "just right" throttle setting with them unlike the notched ones which can be too fast or too slow from one notch to the next. We had them on all our H's and M's in the 50s. They are advertised in "Red Power Magazine" and our CNH dealer can get them. Check with yours, he should be able to also. boog
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|