Farmall & IHC Tractors Discussion Board |
Re: Rebuilt H engine,now what!?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 15, 2002 at 07:12:14 from (24.169.120.138):
In Reply to: Rebuilt H engine,now what!? posted by TBR on June 15, 2002 at 06:35:17:
I'm sure you will get other opinions, but here's how we've been doing it: 1 - Before starting the first time remove the spark plugs. Now roll the motor with the starter until oil pressure shows and stabilizes on the gage. 2 - Replace the plugs and start the motor. Let it idle 15 - 30 minutes while watching the oil pressure, checking for leaks, etc. OK to briefly run it up to full RPM a few times, but without any load. 3 - With the motor now fully warmed up, remove the rocker box, retorque the head bolts and check/reset the valve clearances. 4 - If possible now run the motor under light, variable load (pulling a wagon is ideal) for several hours at least. Or if pulling a heavy load, pull in a lower gear than normal and vary the RPMs every few minutes. Stay away from continuous full throttle/full load operation if possible. Keep an eye on the oil and temp gages - don't let the motor overheat! 5 - Finally drop the oil and replace the filter. Once that's done, let 'er rip! Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|