Farmall & IHC Tractors Discussion Board |
Re: Re: Super A Hydraulic Touch Control Guage not working
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JohnPA on June 14, 2002 at 10:44:41 from (128.118.196.44):
In Reply to: Re: Super A Hydraulic Touch Control Guage not working posted by ScottyNY on June 12, 2002 at 19:27:00:
Scotty, It sounds like you know your touch control pretty well. I have a question or two myself. I have a 100 with touch control. Must have run low on fluid and overheated it (the gauge on mine is unreadable too, and the pump started smoking when the tiouch control quit working. I need some help finding the right repair schematics or manual before I dig into this. Any hints? E-mail me back at jrh3@ems.psu.edu John
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|