Farmall & IHC Tractors Discussion Board |
Re: 4.125 pistons in M block
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bud barenie on June 12, 2002 at 15:39:31 from (208.23.115.26):
In Reply to: 4.125 pistons in M block posted by Flyin Farmall on June 11, 2002 at 19:17:27:
just rebuilt a super m. used pistons from 1 motor and put them into the next !!! i want to go to 4.25 on the next rebuild!!!! which means i have to hone the block!!! i say , they all say, that you can run in the block!!! ih had some engineers who probably didn't fall out of a tree!!! running in the block is different !!! must be pulling !!! i say buy a 450 block, or i have a nice 264 block for sale for 450.00!!! am i trying to make a buck , yes !!! but you bought an m, next time do the math !!! p.s. doing it the hard way !!! mine was burned in a fire!!! i'll never do that again!!! just getting ready to set the hood, totally restored!!!!for pulling!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|