Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Saginaw 3-point hitches
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian Schmidt on June 05, 2002 at 20:18:17 from (207.179.197.196):
In Reply to: Re: Re: Saginaw 3-point hitches posted by K.B. on June 05, 2002 at 19:44:44:
K.B. I have one of the hitches on my C. I have pictures online at the link here. It only bolts to the rear end hsg. I have been going to rig up a tie at the bottom to the factory drawbar. When lifting very heavy 3 point attachments, the hitch stresses a little and you don't get the full lift. The 200 is the same exact tractor. So I would assume the 230 and 240 are the same too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|