Farmall & IHC Tractors Discussion Board |
Re: farmall oil pressure gauge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on June 05, 2002 at 18:49:29 from (216.46.130.70):
In Reply to: farmall oil pressure gauge posted by bob on June 05, 2002 at 17:59:31:
Bob, I would get an oil pressure guage and hook it up to make sure there is adequate oil pressure, then you can decide on keeping your guage or not. There are reproduction guages on the market for less than $20 that will fit your H like a glove. I have two H's and I put a new guage on one of them( $15). The other H has a gauge that works fine but the face of the guage is all discoloured and I am pleased enough with the reproduction guage that I am going to replace it as well. My local Case-I-H dealer can still get original H guages, just a little costlier. Good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|