Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: H/460 wf compatablility
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 04, 2002 at 17:19:18 from (209.226.106.50):
In Reply to: Re: Re: Re: H/460 wf compatablility posted by RPM on June 04, 2002 at 14:12:21:
We have bearing suppliers here in Canada that advertize, "If you bring in your axel shaft and wheel hub, we will match it with bearings, inner cones and seals, providing the hub is large enough and axel shaft is within an inch in length." If that not be the case they can provide a hub to match wheel. I know a guy who put 656 wheels on a 300, both IH front ends. I priced out 8 stud hubs and bearings for my trailer that is currently 5 stud. I wanted to be able to use same wheels on trailer as 3/4 ton truck These guys can match just about any thing close. No it is not IH or Schwartz stock and probably doesn't have the quality. As Wes said in an earlier post he was only going to tinker with, play with and show it off a bit. Then again these bearings could be comming from same source as CaseIH.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|