Farmall & IHC Tractors Discussion Board |
Re: International 300U weights
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on May 30, 2002 at 20:01:12 from (209.245.11.131):
In Reply to: International 300U weights posted by chris on May 30, 2002 at 10:46:14:
Taking your items in reverse order: 3) The 300U originally came with either 28" rims(10- to 13-inch width tires) or 26" rims (14-inch width) for pneumatic tires. Also see a note for 24" rims in the parts book, but this appears to be a special. 2) The wheel weight IH intended for the 300U is not the same as the standard one used on the Farmall tractors. 300U used 65-pound split weights, part #365321R2, which are probably as scarce as hen's teeth. Weights from other manufacturers are commonly used instead. 1) How much, if any, probably depends on how much you want to pick up, and how much stress you want to put on the front axle and steering (which is a notorious weak spot on the 300U). Ballast in the rear tires would give you 700-1100 pounds, depending on the tire and how much calcium is used. That might be enough to be useful, but little enough to keep you out of trouble. I'd strongly suggest that you go with the minimum spacing on the front axle, regardless. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|