Farmall & IHC Tractors Discussion Board |
She's alive
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lee_tx on May 30, 2002 at 18:41:31 from (66.82.32.1):
I bought a Super A about a month ago and finally got the engine rebuilt today. he engine was in pretty bad shape with several pistons stuck and one frozen to the sleeve. I put a 3 1/8 kit in with high compression pistons. Replaced the 6 volt coil (that was shot) with a 12 volt and replaced the battery( also shot) with a 12 volt. Anyway, this afternoon I put some gas in and hit the starter. The engine turned about 1/3 turn and fired right up. I was pleased and suprised. I didn't have the radiator installed so I only ran it for about 30 seconds but the sound of that engine running was music to me. Thanks to Big John and everyone else that helped. I do still have one problem. I don't think that I have the crank shaft pully in far enough because when I tried to install the fan it touched the pully and the pully doesn't line up with chrnk pully. Any suggestions will be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|