Farmall & IHC Tractors Discussion Board |
Re: Think I got me a stock 2nd puller
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by joe on May 29, 2002 at 20:40:46 from (66.43.207.226):
In Reply to: Think I got me a stock 2nd puller posted by Bob-Wyo on May 29, 2002 at 20:29:43:
i'm not sure how to remove lots of weight, but do they let you take sheet metal off? you would loose 50# there. And then you can take the PTO off, since you most decidedly will not be needing it. And take off any hydraulic valves you have, and if you have a hydraulic drawbar (2 pt. hitch) take it off and put a conventional one on. Take headlights off, you will loose a few pounds there. Just strip everything that is not absolutely necessary. Heck, take the knob off the gear shift for all that matters!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|