Farmall & IHC Tractors Discussion Board |
Re: 574 BRAKES:HAVE TO PUMP THEM
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig MO on May 26, 2002 at 16:58:53 from (216.139.97.119):
In Reply to: 574 BRAKES:HAVE TO PUMP THEM posted by MARK on May 26, 2002 at 10:12:43:
To bleed brakes you will need to pinch off leakoff line going to top of transmission cover. Open both bleed screws put line from bleed screw to transmission fill plug. Rev tractor to 1500 rpms and push pedals down when bleed line has no air bubbles close screw. If you can pump up brakes and then lose them or after you bleed them you lose them again check the keep full tubes in the brake resivor on top of the brake valve. They have a tendency to do this over a period of time and you will have to slide tubes up to keep ready supply of oil to the brakes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|