Farmall & IHC Tractors Discussion Board |
Re: Re: Re: New Brakes on 560D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by woodmaster on May 26, 2002 at 05:05:45 from (198.109.215.126):
In Reply to: Re: Re: New Brakes on 560D posted by Keith A on May 26, 2002 at 03:52:34:
when you do your brakes which are very simple as Hugh said.If you put new disc on make sure you take a die grinder and go over all the edges on bothe sides of disc where the disc slides on the splined shaft to prevent any locking up,also if there is a ridge on the housing where the outside edge op the disc would be I took a 4&12 in grinder with wire wheel and the die grinder first to smooth that groove off.Also whem you have that actuator apart clean it real good with the wire brush and make sure you dont have any flat spots on the steel actuator balls,and when you put the actuator back together use a high temp anti seeze on the balls and in the grooves they work in so it will not hang up.Maybe you will only have to tear yours apart once.This is all from experience and I learned it all on this and redpower forum,I just done mine on the 560 about two months ago,but I had to take mine apart about 4 times you should be able to do your just once if you follow these steps.If you have any ? woodmaster@ modempool.com Feel Free
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|