Farmall & IHC Tractors Discussion Board |
560 clutch housing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by larry on May 25, 2002 at 04:59:29 from (198.109.215.148):
There is two holes on the bottom of the clutch housing,one has a plug and the other is open and right below and to the side of the hydraulic filter.can someone tell me the purpose of this hole?I looked at another 560 gas and it was the same way after I cleaned all the sludge out of it.when I shut mine down some oil drips out of it,I beleive it is hyd.but my oil pan leaks a little(not sure if it is fixed yet)could there be a vacume that is sucking some oil up in it and releasing it when I shut her down?This happened after I disced about 50 acres.This is a freshly built motor could the mechanic done something wrong? HELP its driving me crazy afraid I am going to have to split myself and make sure it is all well
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|