|
Farmall & IHC Tractors Discussion Board |
My Tractor fell over
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill S on May 24, 2002 at 11:20:42 from (206.243.130.31):
I'm painting my A and I am jacking up the rear and palcing those cheap stnachoions underneath it to hold up the rear. I remove the left wheel, and everyhting is fine. Then I take off the weighted right rear and lo and behold, the darn tractor tipped over and fell. Good thing nobody was on the other side. It just plain fell on the heavy offset engine side and oh man did I laugh and cry at the same time. I'm ok. I had a heck of a time trying to get the jack underneath to lift it up. But I evenutally raised it up and put better blocking underneath and not the cheap tripod adjusteblae lift things. They are too wobbly and caused my tracotr to fall over.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
