Farmall & IHC Tractors Discussion Board |
Re: Re: H lift all
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD on May 23, 2002 at 11:36:50 from (64.68.166.199):
In Reply to: Re: H lift all posted by Matt K. on May 23, 2002 at 09:16:48:
The remote control for the Lift-All was optional equipment & lots of old tractors simply didn't have it-too many $. Lift-All's lift out of the sides of the pump housing, most had 3 (total) 1/2" pipe nipples through the housing, then 90 degree elbows & plugs showing - 2 on one side, one on the other. They will lift a lot out of any one of these outlets, but only one way without the remote, just pull back on the rod on the right side of the pump. It'll snap back by itself to the notch on the rod when its reached its maximum pressure. I've used mine on modern 2-way cylinders (high pressure?) with good success, but you have to have a vent on the second outlet of the cylinder. Gravity brings the implement back down, just like in the "good old days", but no draft control. (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|