Farmall & IHC Tractors Discussion Board |
Re: All true farmall lovers answer this!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve on May 19, 2002 at 20:28:29 from (65.128.140.232):
In Reply to: All true farmall lovers answer this!!!! posted by Casey on May 19, 2002 at 19:50:05:
I think it takes about 20HP per 16-inch plow bottom so the H could handle maybe 2, 14 inch bottoms in medium to light soil. It would do good to handle 1 bottom in clay or gumbo. A 8 ft. to 10 ft. disk with 14 inch blades is as big as it could handle unless you didn't set the disk to cut too much. I havent seen an H with a 3-point or wide front but the size of implements would be the same, whether 3-pt or pull type. Sorry I dont have any pix of an H.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|