Farmall & IHC Tractors Discussion Board |
Re: Re: International 574 D239 Oil Breather Problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Bob on May 19, 2002 at 13:23:15 from (213.1.68.191):
In Reply to: Re: International 574 D239 Oil Breather Problem posted by IH Neal on May 17, 2002 at 03:54:12:
Overhere in England we had a similair problem when the tractor was ploughing and the one set of wheels were in furrow this was easily cured by a modification that was from IH at the time it is no longer available but somthing very similair is fitted to the newer models all you do is blank of the breather on the camshaft inspection plate and purchase a new rockerbox cover with breather and filter built into it We also had a problem with oil leaking out of the breather after a engine rebuld and it turned out that we had fitted tapered top rings to the 1st ring groove instead of the standard square ring this was fixed when we fitted the correct piston rings hope i have been of some assistance
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|