Farmall & IHC Tractors Discussion Board |
Re: SUPER A ENGINE QUESTIONS
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on May 19, 2002 at 03:31:43 from (216.208.58.158):
In Reply to: SUPER A ENGINE QUESTIONS posted by DAVID BENTLEY on May 18, 2002 at 20:01:52:
David: I talked with a CaseIH parts man about the piston question, not long ago. This parts man has been at it for forty years. I have two of these tractors, Super A and 130 hence I have C113 and C123 cubic inch engines. There were for my 130, four different pistons and sleeve sets I could order. I suspect if we had looked at Super A and 113 engine we would have found the same. I have not ordered yet as the matter is not pressing and am quite busy. I guess right now is as good a time as any to ask forum advice on which set to use, which is what I planned to do next. On the bolt question I assume one is a bolt with head on it and the other is a bolt with threads on both ends. I think you will find that is a year of production change. The bolt with thread on both ends probably has fine thread on nut. The fine thread would give you more fine tuneing so to speak on torqueing head.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|