Farmall & IHC Tractors Discussion Board |
Re: M clutch issues...again
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on May 17, 2002 at 16:55:48 from (129.37.117.113):
In Reply to: M clutch issues...again posted by Dave from MN on May 17, 2002 at 08:16:58:
You don't mention the pilot bearing and as best I read, neither did anyone else. Did you replace it?? Did you lube it?? On the M, there is a way to grease the pilot bearing. The flywheel has a recess in it with a zerk fitting. You access it by turning the engine until the zerk is at the hole in the bottom of the clutch housing just under the fly wheel. May be hard to find, as often the recess is full of dirt and grease. If you did not change the pilot bearing and did not lube it, it could well be that the pilot bearing has enough friction to keep the drive shaft and the gears turning. On the M, if you have the Lift all in there, it should provide enough drag to stop the gears fairly quickly. If you lube the pilot bearing through the zerk, only give it a couple of strokes, as you don't want to get grease on the clutch facing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|