Farmall & IHC Tractors Discussion Board |
Re: Required Tools - (Must haves?)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on May 17, 2002 at 09:18:57 from (216.196.13.66):
In Reply to: Required Tools - (Must haves?) posted by Mitch - MS on May 17, 2002 at 08:59:17:
Well to start a good set of splitting stand , a real good cherry picker of at least 2 ton cap. a real good floor jack of at least three ton cap. Then there tools that you can not get unless you happen to buy out and old IH dealer like i did, you can have a machine shop make seal drivers that are needed or yo can screw up a half dozen of them tryen to in stall and you must have the rear crank seal installer to install that one and get it rite then there is the set up tool to set the ring and pinion depth, and the special socket for the lower contershaft and the tool to remove the Quill and t/a assy. and the list goes on but you get the idea.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|