Farmall & IHC Tractors Discussion Board |
Re: Knocking in Farmall H second gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Casey on May 16, 2002 at 17:41:24 from (205.188.196.26):
In Reply to: Knocking in Farmall H second gear posted by Bryce on May 16, 2002 at 16:21:15:
Your NUTZ for spliting the tractor to do a tranny job on an H! i bought an H about 7 months ago too and i boguht it as is, and it had a terrible nock ni all gears! which indicated the consant mesh and main drive gears were chiped. to make a long story short just drop the hydrolic pump and and clutch and unbolt your shafts and pull them out! i just finishe mine fri afternon still havnt goten arond to start it and test it out! -casey :any advice just holla
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|