Farmall & IHC Tractors Discussion Board |
Re: F-20 Flywheel removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by adam on May 16, 2002 at 16:10:03 from (65.214.64.122):
In Reply to: F-20 Flywheel removal posted by Jim on May 16, 2002 at 10:40:19:
Ive done that three times, and it never gets any easier. First, pull the pin out using a hardened 3/8 bolt and a couple of bigger nuts under it. after that and the nut are out of the way, then the hard part starts. apparently, i h shops had a tool to use. you don't pull the flywheel off, you push it off using the 3 larger 1/2 inch or so holes arount the outsidde. find something really hard, i thinh head studs work and put it in the hole. cut it off so that you can get a bolt threaded in the hole and with the stud under it push agins the back of the motor.you will not be able to see what your doing, but trust yourself. you have to do all three holes this way at the same time and keep the flywheel straigt while comming off. use lots of heat and an impact wrench. this is hard and confusing, but i hope you'll get the idea. adam
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|