Farmall & IHC Tractors Discussion Board |
Re: Taking off Farmall A Crank Pulley
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by geoff gauger on May 14, 2002 at 10:10:58 from (12.155.240.196):
In Reply to: Taking off Farmall A Crank Pulley posted by Pete on May 14, 2002 at 09:51:17:
Don't pull on the O.D. of the pulley, it WILL break. Use a two piece bearing puller behind the pulley and then use a two jaw puller on the bearing puller. Not too sure on the terminology for the gizmo that goes behind the pulley. Anyone know the correct term? Heat will be VERY helpful. When you reinstall, use a threaded rod (1/2" I think) screwed into the end of the crank along with large washers and a nut to draw the pulley on. I put the pulley in the oven before hand, it goes on easier.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|