Farmall & IHC Tractors Discussion Board |
Re: Firecrater pistons
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dan on May 12, 2002 at 16:28:14 from (68.83.34.37):
In Reply to: Firecrater pistons posted by Ron on May 11, 2002 at 20:10:21:
I just finnished rebuilding my super c that came with 3 3/16 firecraters. I was given the standard 3 1/8 pistons at the dealer and didnt even notice untill I got home. as it turns out I didnt lose anything. they are still more powerful than the worn out ones were and far more powerful than the iron pistons in most c and super c tractors. If you decide to use a set make sure you get a distributer advance spring set for them. it is different and so is the timing just a little bit. if you need I can look up the part numbers for you. just let me know.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|