Farmall & IHC Tractors Discussion Board |
Re: Help with International implement, please.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MD Wa on May 11, 2002 at 22:09:23 from (63.231.53.33):
In Reply to: Help with International implement, please. posted by Tom/Idaho on May 11, 2002 at 09:35:02:
Tom. In the early 50es in the sandhill of NE. 2 of us could change all the ledger plates in about a 1/2 hr. on 7ft. bar. Add a 1/2 hr. if we had to replace both end plates. The 1st time will take longer if you have to drill each rivet and use center punch. We used a cold chisel to cut rivets from bottom. Bar in transport pos. Guy on top hold ledger and rivet (3/4 to 1 in. longer than called for) and back up, guy on bottom used 4# hammer bent rivet back, did all ledgers, lower bar and set with punch. Used piece of R/R iron as back up. Guy on end of bar lifted bar just anough to move iron. In 6 yrs. only had one come lose. Hope this of help. Enjoy safely. MD
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|