Farmall & IHC Tractors Discussion Board |
Re: Re: Torque question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on May 08, 2002 at 10:02:00 from (65.59.16.34):
In Reply to: Re: Torque question posted by howard on May 08, 2002 at 05:22:13:
Something easy to look at which will give you a good clue about whether you're likely to run into a problem with a T/A is the clutch adjustments. The main clutch pedal should have about 1-1/4 inch of free play before reaching the friction point. The T/A clutch should also have free play, on the 300U the spec calls for about 3/16 inch of free space in the T/A clutch adjustment clevis, but this probably varies in other models. Another thing to look at is the amount of adjustment left in the adjustment clevis - which can give you an idea of how worn the clutch is. I've looked a number of IH tractors with T/As and maybe 50% have had one or both clutch adjustments wrong. Took one of these for a test drive, and had the transmission lock up (didn't buy that one).
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|