Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH 7' sickle mower adjustments
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on April 28, 2002 at 20:45:34 from (64.228.12.181):
In Reply to: Re: Re: IH 7' sickle mower adjustments posted by Joe on April 28, 2002 at 20:22:26:
Joe: Ledger plates are the plates the knives cut against. They are 1" wide and 2.5" long and are rivited to the fingers. You can tell if there worn by condition of serated edge. They should feel sharp as you slide fingers across them, be careful they may be sharp. There used to be specific tools for changing them don't imagion you can buy them anymore. If you have to hire a welding shop to change them you may be as far ahead to buy whole fingers. Take a finger off and go to dealer, compare cost of doing either way. It has been years since I've done one, don't know prices. Also the top plates or hold downs if worn to sharp edges should be replaced. Hugh.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|