Farmall & IHC Tractors Discussion Board |
Re: Farmall H 5th Gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mr. J on April 26, 2002 at 19:19:14 from (64.200.53.105):
In Reply to: Farmall H 5th Gear posted by Bob on April 26, 2002 at 18:59:13:
Bob, On my 1939 M, the lockout screw is located under the rear gas tank support. The bolt was located directly in front of the shift lever, and the bolt had almost rusted into the transmission deck cover. I had to use a cold chisel to remove it. There was no head left on the bolt itself. However, the purpose of the bolt was to keep the shift linkage from going into 5th. It sounds like your tractor is going into 5th, I hope you don't have any larger problems. If you can get the bolt out, replace it with a bolt that is about 1.5" long. That should fix the problem. Good Luck!! I enclosed a picture of the bolt I removed from my tractor and the hole it came out of. You might have to cut and paste the address of the picture to see it. http://www.geocities.com/tallfarmboy/Bolt.JPG Take care, Jared Jeffries
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|