Farmall & IHC Tractors Discussion Board |
Re: Hydraulics killing engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cd on April 24, 2002 at 19:05:37 from (205.130.19.163):
In Reply to: Hydraulics killing engine posted by K.B. on April 23, 2002 at 14:29:57:
Provided that its not your pump problem, I would go looking at the relief valve we talked about before. Its job is to relieve the excess pressure and that pressure is whats killing your engine. Even if it were your fitting, vavles, cylinder, etc. the relief valve would let it flow and not stall. Tear it apart again and clean it up good and try it again, it seems to take a few times to get it right. A good way to check on your relief is when you turn the tractor off of how fast the engine comes to a stop. My engine would pull down but I never stalled it with the pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|