Farmall & IHC Tractors Discussion Board |
M Differential Dilema
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dagger on April 21, 2002 at 09:47:45 from (206.9.216.79):
Hello all, I took the left side of my '47 M apart to replace the Bull Pinion brgs. on that side this morn. I thought I would be "in and out" in no time but got a little surprise. When I did the right side last fall I replaced both brake bands and the seal. When I took it apart I found the new seal already leaking and just a little lube on the new band. I rocked the brake drum and it had alot of play both up and down and in and out. I took it down the rest of the way and found that the brgs. had been replaced already. The outer brg has "hogged out" the bull cage (in and out play, repacement required) but I feel the the carrier splines have been abused to the point that they are tapered out, causing the the bull pinion shaft to oscillate, thus causing the excess stress on that outer brg, and seal failure. If I just pop in a new brg. without addressing the looseness at the carrier splines, I will ruin an expensive brg. and bull cage. Kow much play have you folks experienced in the past...I suppose I'm in for a new carrier...OUCH!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|