Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall Cub Weight
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan Kelley on April 20, 2002 at 07:09:31 from (216.229.35.64):
In Reply to: Re: Re: Re: Farmall Cub Weight posted by jal-SD on April 19, 2002 at 12:14:11:
You know, I was thinking about putting a second set of weights on my M. I was moving some steel with my front loader, and the back got awfully light when moving a stack of sheet. Then, of course, I lost traction when my front tires went into a shallow depression. I had to set the load down and back out of the trenches my rears dug. Fortunately, I'll only need to move that stack of sheet once more, and I've been very careful to lift it only a foot or so off the ground--just enough to move it. Building a 50'x75' machine shed. :-) _$%^@ homemade roll bar on my M is 3" too tall for the garage doors! (Get out the welding torch.)
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|