Farmall & IHC Tractors Discussion Board |
Re: 1456 too much hp
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Reaper on April 19, 2002 at 20:43:50 from (63.75.191.193):
In Reply to: 1456 too much hp posted by JC on April 18, 2002 at 20:10:52:
take the cap off the top of the roosa master and you will have to remove a rod and spring if I remember correctly to get to the leaf spring.rotate the engine to where you can see a allen head hole in the bottom of the pump cavity,insert a correct size allen wrench and back off (counterclockwise)a quarter turn at a time.reinstall pieces and give it a test run.my 1206 is set 3/4turn back from bottomed out.this controls amount of fuel cc's My 1206 was the same way and had to be adjusted down,scared to blow her up.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|