Farmall & IHC Tractors Discussion Board |
Re: MW clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig MO on April 19, 2002 at 20:12:18 from (216.139.97.173):
In Reply to: MW clutch posted by Scott Buckendahl on April 19, 2002 at 18:52:44:
This gives you live pto. You don't have to push clutch down to stop tractor, just pull hand clutch lever back. When lever is back and foot clutch pedal out your pto still turns. As far as adjusting take out one 5/16 bolt on cover and loosen the other one. Turn cover and you will see an adjusting nut. Bend lock tab up out of adjusting nut and turn in about 1/4 turn. Put cover back on and engage and disengage lever should take about 30 lbs. to do this and have a good snap. Repeat above process until you have it adjusted. Make sure you lock tab back down in adjudtig nut slot when done.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|