Farmall & IHC Tractors Discussion Board |
Re: Setting Valves on a Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Shuler on April 19, 2002 at 11:45:36 from (152.163.207.181):
In Reply to: Setting Valves on a Farmall M posted by Dan Kelley on April 19, 2002 at 06:45:28:
Hi Dan, I did mine just like Red said, ran it for a while and found quite a bit of difference on recheck.It was hard for me to tell when the gap was all the way open. I started the tractor with the valve cover off at the slowest idle it would run and adjusted each one with a feeler gauge while it was running. Viberates your hands a little but smoothed it out considerable. It will sit there and purr now and the rain cap will raise about a 16th of an inch and just sit there at idle.I did it just like Red said but only running. Its not messy, it's fast and it seemed to work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|