Farmall & IHC Tractors Discussion Board |
Re: Setting Valves on a Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on April 19, 2002 at 09:24:34 from (12.84.242.139):
In Reply to: Setting Valves on a Farmall M posted by Dan Kelley on April 19, 2002 at 06:45:28:
Dan it is very straight forward. I set them at .018 cold. Front front to back, the valve arrangement is exhaust intake, intake exhaust, exhaust intake, intake exhaust. I start with #1 cylinder and watch the exhaust valve open and close then watch the intake immediately open and close after that. Then I slowly turn the pulley until the knotch is lined up on the timing mark. That will put #1 on TDC compression stroke. Use a 1/2 inch open end or box wrench and a large screwdriver to adjust your tappet gap.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|