Farmall & IHC Tractors Discussion Board |
Re: Question went unaswered on CASE board
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD Humm on April 10, 2002 at 15:56:23 from (67.203.73.118):
In Reply to: Question went unaswered on CASE board posted by Brent on April 10, 2002 at 11:15:22:
I have taken the head off of a mechanic's magnet and clamped it to a piece of rubber hose, like 3/8 id and 36 inches long before to retrieve metal pieces in places I could not ordinarily get to with a stiff armed magnet. Might try that. Anhydrous ammonia applicator hose was what I used but any small hose would work. I once dropped a 3/8 inch combination wrench into the rear end housing on Dad's 1030 Case years ago while adjusting the power take off clutch and retrieved it with the hose and magent method. Took a while but it worked.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|