Farmall & IHC Tractors Discussion Board |
Re: 806 Loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cb on April 08, 2002 at 12:51:41 from (207.54.105.157):
In Reply to: 806 Loader posted by Dave on April 08, 2002 at 10:54:42:
An IH 2350 mount o matic should fit ok. You may need to drill some 5/8 holes in the frame rails for the mounting brackets.And the tractor needs two hyd.valves to run it. The 2350 is an easy loader to mount or unmount in 3 to 5 minutes and dont need any wrenches.The long hose are the only big to handle. We have mounting brackets on our 756D and 826D so we can use it on ether tractors. The brackets on the 756 we fabricated ourself's and work just as well as the set that came with the loader.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|