Farmall & IHC Tractors Discussion Board |
Re: OUCH!!! Sheared bolt!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim Malin TO ALL OF YOU on April 07, 2002 at 16:58:56 from (207.190.93.43):
In Reply to: OUCH!!! Sheared bolt!!! posted by Tim Malin on April 07, 2002 at 15:35:15:
The bolt is located: There is a large, probably 1 and a half inch diameter pin where the drawbar itself connects to the tractor straight underneath. When the pin is in place, a 9/16 headed bolt goes into the casting with a small 1x1 inch piece of flat steel to hold the large pin up. It doesn't take much, so it isn't much. However, I may be able to try with a vice-grips, but I think the easy out might by the way to go. Keep the responses coming, I learn something new with each one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|